Blog

Flash flooding and the region's stormwater system

Why Chicago floods in summer storms, what the Deep Tunnel and reservoirs do, who handles sewers and basements, and what to do when water comes in.

Flat ground, low ground, a lake next door. That is Chicago, and in July and August the city catches the heaviest rain of the year in short, violent bursts. A thunderstorm that dumps two inches in an hour can turn an underpass into a pond and push water into basements blocks from the nearest creek, because there is no creek. The water is in the pipes under the street, and the pipes are full. Here is how the system that handles all that water works, who runs which part of it and what a resident can do.

Why does Chicago flood so easily?

Start with the land. The city was built so low that in 1856 the City Council voted to raise the entire grade of the city by four to five feet, and buildings were jacked up on screws to meet the new streets. Natural drainage was slow, and the city's engineers answered it with sewers, a canal and eventually a reversed river. The Chicago Sanitary and Ship Canal opened on January 2, 1900, carrying the river's flow away from the lake and toward the Illinois River. The history is told in Reversing the river: the Sanitary and Ship Canal and raising the city out of the mud: the 1856 grade decision.

Add three conditions. Summer is the wettest season, with July and August the wettest months of the year and thunderstorms often arriving at night. Annual precipitation at Midway averages 40.88 inches, but much of it comes in short intense bursts rather than steady rain. And the city is mostly paved, so rain that would soak into soil runs straight into storm drains and combined sewers. When the pipes fill, water backs up to the lowest points: viaducts, street corners and basements.

How much water are we talking about?

A rough calculation shows the scale. One acre of ground covered with one inch of rain receives about 27,154 gallons. Chicago's land area is 227.73 square miles, which is about 145,700 acres. One inch of rain across all of it is therefore close to 4 billion gallons, about 3.96 billion. That is the entire amount, not the share that runs into pipes, since some soaks in or evaporates, but even a fraction of it dwarfs the capacity of any pipe. A storm of two or three inches over an hour or two sends a very large volume of water toward the sewers at once.

Who is responsible for what?

Chicago's flood system has two layers, and once you see them, most of the confusion clears up.

The city. The Department of Water Management, covered in Chicago Department of Water Management, runs the city's sewers and water mains, and flooding and water issues go through 311. DWM also handles the sewer system that collects rain and wastewater from streets and buildings in the city. It is the city's job to maintain the pipes and catch basins that carry the water away from your street.

The region. The Metropolitan Water Reclamation District of Greater Chicago (MWRD), covered in Metropolitan Water Reclamation District of Greater Chicago, treats wastewater at seven water reclamation plants for Chicago and 128 surrounding communities. It also manages stormwater across Cook County, with capital projects, stream maintenance and regulations, and it works in six watersheds: the Cal-Sag Channel, Lower Des Plaines River, North Branch Chicago River, Poplar Creek, Little Calumet River and Upper Salt Creek. The city's sewers feed into the district's regional system. The MWRD's annual budget is about $1.5 billion.

In plain terms: the city owns the pipes under your street, and the district owns the big tunnels, reservoirs and treatment plants that take the water from many cities' pipes. Water that overwhelms the first layer has nowhere to go but your street or your basement; water that overwhelms the second layer can reach the river or, historically, Lake Michigan.

What is the Deep Tunnel?

"Deep Tunnel" is the nickname for the Tunnel and Reservoir Plan, TARP, the MWRD's system of deep, large-diameter tunnels and large reservoirs. Much of Chicago and its older suburbs have combined sewers, which carry both sewage and rainwater in the same pipe. In a heavy storm those pipes can overflow, sending a mix of rain and sewage into rivers and canals. TARP is designed to catch that overflow, hold it underground and release it to be treated when the storm has passed. The district describes it as a system that reduces flooding, improves the quality of the waterways and keeps sewer overflows out of Lake Michigan.

A few numbers give a sense of its size. The tunnel system runs roughly 110 miles, bored deep under the region, and it feeds large reservoirs. The Thornton Composite Reservoir, a former quarry, has storage of about 7.9 billion gallons. The McCook Reservoir, another quarry, is planned to hold about 10 billion gallons when its second stage is complete. The mileage and capacity figures vary slightly depending on the document and the date, because the system has been expanded in stages, so the district's own pages are the place for current numbers. For a sense of scale, compare these with the roughly 4 billion gallons that one inch of rain would deliver across the whole city.

The tunnels are not a cure for every flood. They are built to handle sewer overflow and reduce river flooding on the regional scale, not to keep water out of an individual basement. A tunnel full of storm water does nothing for a block whose local sewer has backed up.

Why does my basement flood if the tunnel is working?

Basement flooding in Chicago usually has one of a few causes: a storm so intense that the local sewer cannot take the volume, a backed-up combined sewer that pushes water into a basement drain, water seeping through foundation walls or window wells, or a failed sump pump. The Department of Water Management has installed restrictor valves on many streets, which hold water on the street for a time so that overwhelmed sewer mains do not push it into basements. During the heavy rains of July 2023, an analysis of 311 data counted more than 12,000 basement flooding reports in 17 days, from July 2 to July 18.

What can I do about it?

Residents have both private and public tools.

  1. Report it. Call 311 or use the CHI311 app to report water in a basement or a flooded street. The reports help the city track the problem; Using 311 and the CHI311 app explains how.
  2. Consider backflow protection. The usual private fixes are an overhead sewer, which keeps sewage from coming back up the drain, or a flood-control system at the drain. A sump pump can remove water that is already in a basement, but it needs electricity. Permits are required for this work in Chicago, so use a licensed contractor; Getting a building permit in Chicago explains the permit process.
  3. Know about the Private Drain Repair program. The Department of Water Management offers a program for repairs of broken private sewer drains under the public way for buildings of up to four units. The department's page describes eligibility.
  4. Look at your own property. Gutters, downspouts, window wells and the slope of the ground around the building matter. Rain barrels and rain gardens, which community programs such as RainReady have promoted, slow the water before it reaches the sewer.
  5. Keep records. Photograph damage, and check what your insurance covers; a standard homeowner's policy often excludes sewer backup unless it has an endorsement, so ask your insurer.

What should I do in a flash flood?

Flash flooding is a danger on the street as well as in the home.

  • Do not drive into water. Viaducts and underpasses can fill quickly and stall cars. Turn around.
  • Stay out of flooded basements. Water can hide electrical hazards, and sewer backup carries bacteria. Turn off power only if you can reach the panel safely and dry; otherwise call for help.
  • Watch the alerts. The weather service's Chicago office issues flash flood warnings, and NotifyChicago can carry them to your phone; see Signing up for the alerts that matter: NotifyChicago and weather warnings.
  • Call 911 for an emergency, 311 for flooding that is not an emergency.

Watch, warning, advisory: reading a flood alert

The weather service uses a standard vocabulary that applies in Chicago as anywhere. A flood watch or flash flood watch means conditions are favorable for flooding, so it is time to prepare: move valuables off the basement floor, clear the drain at the bottom of your stairs, and think about where you would drive. A flash flood warning means flooding is happening or about to happen, and it is time to act: stay out of low areas and underpasses, and avoid driving. An advisory usually covers a lesser nuisance flood, such as ponding on streets. Warnings reach phones through the national wireless alert system and through NotifyChicago for those who have signed up, and the Chicago weather office's pages at weather.gov/lot show the active watches and warnings for the county.

How big can it get?

The largest water emergency in the city's memory was not a storm. In April 1992 a break in an old freight tunnel under the Chicago River flooded the Loop's basements with about 250 million gallons; see The April 1992 flood under the Loop. It shows how much of the region's water infrastructure is hidden, and how a single failure can turn a quiet day into an evacuation. The ordinary summer flood is smaller, but it touches far more people.

The broader context is the region's weather: Chicago weather by the numbers: NOAA normals from Midway explains why July and August bring the heaviest rain. Between the city's sewers, the district's tunnels and reservoirs and the weather service's warnings, Chicago has a system that works most of the time. The rest of the time, the best protection is a plan: know who to call, know what your basement can do and keep an eye on the forecast.

Related city government

Related guides

Latest on this topic