Blog
The canal, the railroads and the making of a hub
The 96-mile Illinois and Michigan Canal and the Galena and Chicago Union Railroad both opened in 1848, and together they turned Chicago into the nation's hub.
In 1848 two things started moving through Chicago, and between them they set the course for the next century and a half. In the spring the Illinois and Michigan Canal opened, and for the first time a boat could travel by water from Lake Michigan to the Mississippi River. By year's end the first rails of the Galena and Chicago Union Railroad were being laid out from the city's west side. Until then Chicago had been a lake port and a muddy village on a portage. After 1848 it was where the waterways, and soon the rail lines, of a continent came together, and a city of a few thousand people turned into one of the largest in the country inside a generation.
A canal in the making
The idea of a canal across the Chicago Portage is older than the city. The French explorers Louis Jolliet and Jacques Marquette noted in the 1670s that a short cut across the low ground would connect the Great Lakes to the Mississippi, and the engineer Stephen Long surveyed a possible route in 1816 (the route they described is the subject of The Chicago Portage: the short canoe route that made a city). The state of Illinois began digging in 1836. The work stalled in the financial panic of 1837 and dragged on for another decade. The canal was paid for by selling federal land that Congress had granted to the state for the purpose, and by loans from eastern and British investors. Irish immigrants, many with experience on the Erie Canal in New York, did most of the digging, and many of them died on the job. The final cost was $6,170,226.
What the canal was
The Illinois and Michigan Canal ran 96 miles from the South Branch of the Chicago River at Bridgeport to the Illinois River at LaSalle-Peru, following the old portage route. It was 60 feet wide and 6 feet deep, with towpaths along the bank where mules pulled the boats. To handle the 140-foot change in elevation along the way, it had 17 locks and four aqueducts.
A little arithmetic gives the feel of the project:
- Cost per mile. $6,170,226 divided by 96 miles is about $64,300 a mile, in the money of the 1830s and 1840s.
- Lift per lock. 140 feet of elevation change over 17 locks is an average of about 8.2 feet per lock.
- Slope. 140 feet over 96 miles is a drop of about 1.5 feet per mile, gentle enough that the canal ran as a series of long level stretches.
The canal's Chicago end was at Bridgeport, a neighborhood described in Bridgeport.
What the canal changed
Once it opened in 1848, the canal tied northern Illinois to the East. Farmers could ship grain and livestock to Chicago and on to the Great Lakes and the Erie Canal, and goods from the East could travel the other way. Eastern markets made farming in northern Illinois pay, and the growth of the region's farms and of Chicago's lakefront grain trade followed.
The same year brought other pieces of the commercial machine. Steam-powered grain elevators arrived in 1848, speeding the handling of grain, and the Chicago Board of Trade was founded the same year. A year earlier, in 1847, Cyrus McCormick opened a factory in the city to build his mechanical reaper, a machine whose customers were the same farmers the canal had enriched. For the later stages of the grain trade and the exchanges that grew out of it, see The exchanges: CME Group, Cboe and the Board of Trade building.
The railroad arrives
The canal's first competitor was already being built. The Galena and Chicago Union Railroad had been chartered in 1836, but nothing came of it, and the line was bankrupt when William B. Ogden, Chicago's first mayor (from town to city: 1833 and 1837), took it over. He was elected its president on February 17, 1846, and with a partner raised money from farmers and business people along the planned route. By 1848 he had $350,000, enough to begin laying track.
Construction began in the summer of 1848. The first four miles went down in October and November, reaching Oak Park, and a first celebratory trip ran from the terminal at Kinzie Street out to Oak Park. The line was meant to reach Galena, the lead-mining town in the northwest corner of the state, and never did; it reached Freeport in 1853 and used another railroad's tracks for the last stretch. It was extended quickly: Elgin by January 22, 1850, Aurora in October 1850, with branches to St. Charles and Beloit and later to the Fox River Valley.
In June 1864 the Galena and Chicago Union was swallowed by a larger company, the Chicago and North Western Railway, in what is called the Great Consolidation, and its name disappeared. The pattern was set anyway. A railroad from Chicago into the farm country, then a second and a third, meant the grain and livestock of the Midwest came to the city by rail as well as by canal.
Why the rails beat the canal
The canal and the railroad were not rivals for long, and the railroad won. The canal moved bulky goods cheaply but slowly, and it froze in winter. A railroad moved goods any time of year, at much higher speeds, along routes that did not need to follow a water course. Passenger service on the canal ended in 1853, after a parallel railroad opened. Canal freight traffic peaked in 1882 and then declined. Two later projects finished the job: the Chicago Sanitary and Ship Canal, opened January 2, 1900, which replaced part of the canal's function and reversed the river (Reversing the river: the Sanitary and Ship Canal), and the Illinois Waterway of 1933, which ended the old canal's commercial operation.
The hub
By the 1850s lines were radiating from Chicago in nearly every direction. The city became the funnel through which the Midwest's farm and forest products moved east and the East's manufactured goods moved west. Grain, lumber and, from 1865, livestock from the Union Stock Yards (The stockyards and the American meatpacking story) all passed through. The population tells it: from just over 4,000 in 1840 to 112,000 in 1860 and 299,000 in 1870.
The same system produced the city's physical form. Rail yards and terminals sat on the edge of the old downtown, the commercial district grew around them, and the neighborhoods of the working population grew around the yards and the factories. Chicago has been a freight center ever since, and how that works today is in rail yards and the freight economy. The passenger terminals are covered in Union Station and Amtrak's Midwest hub.
A trip down the canal, in arithmetic
Picture a boat pulled by mules along the towpath. If the boat averaged three miles an hour, a figure assumed for the example, the 96 miles from Bridgeport to LaSalle-Peru would take 32 hours of steady movement (96 divided by 3), before counting the time spent passing through 17 locks. Even with a few hours added for the locks, a trip took a day and a half or two days. The same trip on the muddy roads of the 1830s could take far longer and carry far less. That comparison is why the canal changed the economy: it made bulk shipping of grain, lumber and goods between the lake and the river system faster and cheaper, and cheaper shipping is what makes a distant market worth selling to.
Who built it, and who moved on it
The Irish workers who dug the canal came to a country with few protections for laborers, and many died during construction. The work was done mostly by hand, with picks, shovels and wheelbarrows, over about a dozen years, from the start in 1836 to the opening in 1848. The people who used the finished canal included farmers shipping grain north, lumber dealers and merchants sending goods south and west, and passengers on boats that carried travelers until the railroads took the business in 1853.
The cargo list is short. Grain and other farm products went toward Chicago and the lake. Lumber, salt, manufactured goods and supplies for the farms and towns of the Illinois valley went the other way. That is why Chicago grew as a market and an exchange: it sat where those two flows met.
Rail and canal in the neighborhoods
The canal and the railroads also fixed the shape of neighborhoods that still exist. A canal needs a terminal, and the area around Bridgeport and the river's South Branch became part of the working waterfront of the canal trade. A railroad needs terminals and yards, and the blocks around the passenger and freight terminals grew with them. Over time the freight yards moved to the edge of the city and beyond, and the old areas changed, as in the Fulton Market district's shift from a meat-trade district to the offices and restaurants described in Food halls and Chicago's old market tradition. But the layout of the city's main commercial streets, the position of its terminals and the pattern of its neighborhoods all owe a good deal to where the first tracks and the first locks were put.
What remains of the canal
The canal was designated a National Historic Landmark in 1964 and became the country's first National Heritage Corridor in 1984. Sections are now a linear park with a 62.5-mile hiking and biking trail that follows the old towpath, and visitors can walk beside the water in towns along the route, from Lockport to LaSalle. A day's trip along the route is described in the canal country southwest of the city.
A timeline
| Year | Event |
|---|---|
| 1673 | Jolliet and Marquette cross the portage |
| 1816 | Stephen Long surveys a canal route |
| 1836 | Canal construction begins; the Galena and Chicago Union is chartered |
| 1846 | Ogden is elected president of the railroad |
| 1847 | McCormick's reaper factory opens |
| 1848 | The canal opens; the Board of Trade is founded; steam grain elevators arrive; rail construction begins |
| 1850 | The railroad reaches Elgin and Aurora |
| 1853 | The railroad reaches Freeport; canal passenger service ends |
| 1864 | The Great Consolidation forms the Chicago and North Western |
| 1882 | Canal traffic peaks |
| 1900 | The Sanitary and Ship Canal opens |
| 1933 | The Illinois Waterway ends the old canal's commercial operation |
| 1964 | The canal is named a National Historic Landmark |
| 1984 | It becomes the first National Heritage Corridor |